DS200 User’s Guide
DS200 User’s GuideDS200 User’s Guide
DS200 User’s Guide
V003. 09.09.2002
C-71
In
InIn
In order to listen to the messages left to you:
order to listen to the messages left to you: order to listen to the messages left to you:
order to listen to the messages left to you:
H
Lift the handset and hear the internal dial tone.
8646
Dial 8646.
B
Dial your password, if you have one.
E
Listen to your message.
Notes:
Notes:Notes:
Notes:
1. You will start to listen to the messages in a row. If you receive dial tone again, then that
means there is no recorded message. The system will transmit music on hold, or, if that
feature is not active, it will transmit silence, in case EVM200L is busy at that moment. In
this case, you may either wait until one of the channels of EVM200L is available and
connected to you, or hang up and try again later.
2. If you do not press any key, then you will listen to the entire messages in a row and then
receive dial tone after the last message.
3. While listening:
-
--
-
If you dial 0
0 0
0, then you return to the beginning of the message you are listening to at that
moment.
-
--
-
If you dial 1
1 1
1, then
you proceed to the next message.
..
.
-
--
-
If you dial 2
2 2
2, then
you return to about 3-3.5 seconds earlier in the message and go on
listening to the same message.
-
--
-
If you dial 3
3 3
3, then the voice level of the message is increased by one step from then on
and you go on listening to the same message.
-
--
-
If you dial 4
4 4
4, then
you jump to about 3-3.5 seconds later in the message and go on
listening to the same message.
-
--
-
You can transfer the message to the extension
aaaa by dialing 5+aaaa.
5+aaaa. 5+aaaa.
5+aaaa.
-
--
-
If you dial 6
6 6
6, then the voice level of the message is decreased by one step from then on
and you go on listening to the same message.
-
--
-
By dialing 7+ aaaa
7+ aaaa 7+ aaaa
7+ aaaa, you can first append another message in front of the message and
then transfer it to the extension
aaaa.
. .
. You should hang up after announcing your
message.
-
--
-
If you dial 8
8 8
8, then
you lock (if you have the necessary authorization) the message you are
listening to, until you listen to it again, and then proceed to the next message.
-
--
-
If you dial 9
9 9
9, then
you erase the message you are listening to and then
proceed to the
next message.
4. Any message left to you is automatically erased 15
1515
15 minutes after it is listened to.
5. The discontinuous dial tone shifts back to normal after you have listened to all messages.
However, this does not mean that there are no more messages.
To Next Page
