17
Ŝ INSTALL ANTI-TIPPERS
To Fit.
Depress rear button and insert into rear of frame.
The forward locating button must engage into retaining hole in frame.
To depress rear button and pull out.
To Detatch
Detach the anti-tippers by reversing this procedure.
CAUTION:
Karma recommends that you should install anti-tippers in any occasion to prevent
you tip over .
5.9 Transportation
Do not use other transportation to pull the wheelchair.
This Karma wheelchair model in its standard configuration has passed crash test
requirements according to ISO 7176-19 regulations. KP-25 series can be used for
transport in vehicles that have been specially adapted for this purpose. The
wheelchair must be securely fastened in the vehicle according to the methods
described on the following pages.
Karma always recommends that the user be transferred into car seat with a safety
belt or harness while in a transport.
5.9.1 Before use
CAUTION:
If the back angle of the wheelchair is adjustable, do make sure that the wheelchair
backrest should be positioned as close as possible to 90 degrees.
Ŗ!Please detach all easily removable accessories from the wheelchair and stow
them in a safe place where they cannot move around and become a safety
hazard.
Ŗ!A four point tie-down system should tightly fasten the lower wheelchair
frame(hook mark ) to the transport vehicle.
Ŗ!An occupant restraint system using both a pelvis and harness must also be
fastened to the transport vehicle to insure user safety. Again, please refer to
the restraint system's instructions.
Ŗ!The attendant / transporter must double-check all fastening points for proper
SUGGESTION:
Remember that the best solution is always to move the user from the wheelchair
into a normal car seat.
To Next Page
Loading...
Need help?
General
