KARPO Fly Fantom Extralight 3 - Page 5

After connecting the backup parachute and the rescue strap, insert the
backup parachute into the container. For easier rescue system deployment,
insert the parachute with the lines down. Then insert the handle into the
neoprene pockets. (rescue straps run under the handle).
After inserting the rescue handle into neoprene pocket, we begin to drag
strings. Lay the cord loop through the 3rd eyelet from the left and secure with
a string. Repeat the same procedure in the following order: the 4th eyeliner
then the 2nd eyelet and nally the cord by the 1st eyelet from the left and
secured with a string.
Pictures below will help you with installation.
3. Inserting rescue system into the harness
3 4
* illustration photo * illustration photo
page 4
www.karpoy.com
The KARPOFLY reserve parachutes are equipped with mailon carabiner,
covered with a neoprene wrapper. To install a backup parachute, simply we
remove the neoprene wrapper from the mailon carabiner, loosen the screw
and snap in harness rescue strap that is rmly sewn into the harness. After
dragging the rescue strap into mailon carabiner, tighten the screw properly
and pull back neoprene wrapper.
The following pictures will help you with the assembly.
2. Connecting the backup parachute and the rescue strap
1 2
* illustration photo * illustration photo