seat and that the child’s back clings tightly to the backrest.
• The braces must t at above the child’s shoulders.
• Plastics ending of the braces must be joined together.
• Next, put the joined plastic endings of the braces into the buckle, until you hear
a ,,click” sound, which is the sound of snapping shut.
• Pull the middle strap located in the front part of the car seat in order to make
sure that the child is tightly held by the braces of the car seat (seatbelt system).
Adjusting the braces
The length of the braces (seatbelt system) should be adjusted to your child’s individual needs.
The braces should be put through the slots located nearest from your child’s shoulders.
All securing tapes mounting the restraining device in the car should be tightened so that all
the tapes holding a child are tightly t to the child’s body and not twisted.
Adjusting the braces (seatbelt system) is as following:
a) Belt-loosening
Press the regulative button located in the front side of the shell and pull the braces at the
same time.
B) Belt-tightening
Tighten the middle belt in the front of the shell until the braces t tight to the child’s body.
A pad with shaping insertion
The Avionaut Kite children’s car seat is equipped with removable lling pad for infants. It
tailors the laying position to an individual child’s needs and holds the infant’s head.
The lling pad may be used longer, after removing the sponge lling. Shaping insertion should
be removed by unfolding the side elements of gauze, and then sliding the side elements
inside. We suggest using the lling insertion until the 5th month of your child’s life.
II. Installation of the Avionaut Kite children’s seat in a car
The Avionaut Kite children’s car seat is suitable for listed vehicles equipped with three-points
static seat belt and three-points seat belt with the retractor, which are in accordance with the
ECE no. 16 standard or equivalent.
While installing the children’s car seat in the car you have to be careful with the following
actions:
EN
To Next Page
Loading...