Wireless ADSL Router USER MANUAL
17
This is the IP address that other devices on your local network will
use to connect to the modem. The default is 192.168.1.1.
This defines the size of your network. The default is 255.255.255.0.
Select this option is to let the device use a second IP on the
LAN interface. You can also use this second IP address to
access the device for management. Enter the LAN IP address
of your device in dotted decimal notation, for example,
10.0.0.1. Type the subnet mask.
IGMP Snooping is a method that actually “snoops” or inspects IGMP
traffic on a switch. When enabled, the switch will watch for IGMP
messages passed between a host and a router, and will add the
necessary ports to its multicast table, ensuring that only the ports
that require a given multicast stream actually receive it.
You have five choices here. 100Mbps/Full Duplex, 100Mbps/Half
Duplex, 10Mbps/Full Duplex, 10Mbps/Half Duplex and Auto
Negotiation.
Select the LAN interface for which you want to use MAC
address control rule. Click Apply Changes to save and apply
your configuration.
Enter the MAC address allowed, for example,
00:0e:f4:33:33:22.
To Next Page
Loading...
