page 1
Switching device on and off
• To turn the device on: press the CALL button for 1
second, all the LEDs will flash rapidly. The device can
also be turned on automatically by placing it in the
docking station.
• To turn the device off: press and hold the side button
and SOS button together for 3 seconds until the LEDs
turn off.
Silent mode
• Double-click the silent mode button to turn off
voice warnings; double-click once more to turn
voice warnings on.
Getting a GPS fix
• To get an initial location for the GPS features, go
outdoors or stand near a window so the device
can get a fix on the satellites. This could take few
minutes, depending on your environment.
Insert the SIM card
The SIM card is not included in the package.
A Nano SIM card is available from the user’s local operator.
• Unscrew the back cover and remove.
• Insert the SIM card and make sure it’s activated and in
credits.
• Replace the cover and tighten the screws.
Before installing the SIM card, check if the SIM card has
a PIN code or not, if yes, please use a mobile phone to
remove the card’s PIN code.
Charging base
• Place the device on the charging base.
• Connect the USB cable from the charging base to the
AC adaptor.
The charging base light will glow when charging and turn
solid when fully charged.
When using the device for the first time, please fully charge
the battery for around 2~3 hours.
When the battery level falls below 20% it will send a low
battery warning message to recipients on the contact list
via text message or phone call.
TIP
EV-04_QG_EN_V1.2_2021.11_Final
EV-04
Personal mobile alarm
system
LTE GPS WIFI BLE
Getting to know your device
Call button
Silent mode
button
Lanyard hole
SOS button
LED light
Microphone
Charging contacts
Screw holes
Charging contacts
LED light
SOS button
1sec.
3sec.
TIP
TIP
To Next Page
Need help?
General
