Need help?Do you have a question about the Kathrein MSK 125 and is the answer not in the manual?
General| Brand | Kathrein |
|---|---|
| Model | MSK 125 |
| Category | Measuring Instruments |
| Language | English |
Outlines essential safety regulations for operating the MSK 125 and proper disposal.
Provides crucial safety instructions to be followed during operation.
Explains how the MSK 125 can be operated using either mains power or its internal battery.
Details the procedure for operating the MSK 125 using the mains power supply.
Explains how to set the MSK 125 for analogue satellite reception.
Instructions for entering transponder frequencies for satellite reception.
How to perform and interpret analogue satellite level measurements.
Explains how to set the MSK 125 for digital satellite reception.
Explains how to set LNB supply voltage and 22 kHz switching for digital satellite signals.
How to perform and interpret digital satellite level measurements.
Explains the DiSEqC system for controlling satellite equipment.
Details the commands for using the DiSEqC™™ system to control satellite equipment.
Lists hex codes and descriptions for command bytes in DiSEqC™™ commands.
Explains data bytes used in DiSEqC™™ commands and provides a table for data byte selection.
Details the SCIF system for single cable distribution, including DiSEqC control.
Explains the simplified DiSEqC™™ procedure for tone burst and data burst.
Details commands for launching DiSEqC™™ and simple DiSEqC™™ menus.
How to measure MER, BER, and carrier frequency offset for DVB-S(2) signals.
Guide on searching for satellites using the FIND function, including sensitivity and bearing tone.
Explains how to set the MSK 125 for analogue cable TV reception.
Guides on selecting channels for TV signal measurement.
How to perform and interpret analogue cable TV level measurements.
Explains how to set the MSK 125 for digital cable TV reception.
Guides on selecting channels for digital cable TV signal measurement.
How to perform and interpret DVB-C signal level measurements.
How to measure MER, BER, and carrier frequency offset for DVB-C signals.
Explains how to set the MSK 125 for analogue terrestrial TV reception.
Guides on selecting channels for analogue terrestrial TV signal measurement.
Explains how to set the MSK 125 for digital terrestrial TV reception.
Guides on selecting channels for digital terrestrial TV signal measurement.
How to measure MER, BER, and carrier frequency offset for DVB-T/H signals.
How to adjust the antenna for maximum signal using the LEV function for terrestrial TV.
Explains how to measure signals in the return path frequency range.
How to perform and interpret FM signal level measurements.
How to adjust the antenna for maximum FM signal using the LEV function.
How to display and analyze the frequency spectrum for satellite signals.
How to display and analyze the frequency spectrum for TV signals in various modes.
How to display and analyze the frequency spectrum for return path signals.
How to display and analyze the frequency spectrum for FM signals.
Instructions on how to save current device settings for later recall.
How to save measurement results to the device's internal memory.
How to retrieve measurement results stored in the device's memory.
How to transfer measurement results from the device to an SD card.
Explains the data logger's capability to execute and store settings and results.
How to define the start and stop points for automatic measurements.
How to retrieve measurement results stored in the device's memory.
How to save data logger measurement results to the SD card.
Explains how to determine the carrier-to-noise ratio (C/N) for analogue transponders.
Provides command sets for Kathrein matrices, including DiSEqC™™ commands.
Lists single cable DiSEqC™™ commands for various systems.
To Next Page
