Kawasaki MULE PRO FXR - User Manual

Page 1 of 29
Assembly Instructions
Model:
MULE PRO FXR
Description:
Bluetooth Audio System
Part Number:
99994 - 0966
Assembly Time:
90 Minutes
Before you begin, read through this entire instruction packet and confirm that all parts are present
and that you have all the tools you will need.
Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect
installation.
Kawasaki recommends that all genuine accessories should be installed by an authorized
Kawasaki dealer.
The following symbols indicate the information for proper installation and operation in this instruction
NOTE: Note indicates information that may help or guide you in the separation or
service of the vehicle.
 Indicates a procedural step or work to be done.
o Indicates a procedural sub-step or how to do the work of the procedural step it follows. It also
precedes the text of a NOTE.
Installation Video
When you are reading this manual electronically,
click on the picture to the right or type the web
address below to watch the “How to” installation
video.
YouTube URL
https://youtu.be/JfBsuv-fc2Y
© 2018 Kawasaki Motors Corp. USA

Summary

Introduction and Preparation

Installation Video Guide

Watch the video for installation guidance.

Parts List Overview

List of all components included in the kit.

Required Tools for Installation

List of tools needed for assembly.

Pre-Assembly Vehicle Preparation

Steps for preparing the vehicle before installation.

Dash Disassembly and Component Handling

Dash Removal Procedure

Step-by-step guide to remove the dash panel.

Shifter Grip and Dash Panel Detachment

Removing shifter grip and pulling the dash forward.

Component Labeling and Disconnection

Marking and disconnecting electrical components.

Finalizing Dash Removal and Grip Reattachment

Completing dash removal and reattaching shifter grip.

Accessory and Source Unit Installation

Mounting the Accessory Input

Installing the USB/3.5mm accessory input.

Preparing and Drilling Dash Pocket

Preparing and drilling the dash pocket for cables.

Mounting the Source Unit

Installing the main audio source unit into the dash.

Securing the Source Unit

Fastening the source unit using Torx screws.

Speaker System Installation

Routing Speaker and Antenna Harnesses

Passing harnesses through the dash for speakers and antenna.

Connecting Speaker and Antenna Harnesses

Connecting the routed harnesses to the source unit.

Mounting Overhead Speaker Pods

Installing the overhead speaker enclosures using MAXX-CLAMP.

Under Dash Speaker Enclosure Mounting

Installing the under-dash speaker enclosures.

Under Dash Speaker Wiring and Connection

Connecting speaker wires and securing enclosures.

Final Wiring, Testing, and Reference

Wiring the Audio System Connections

Connecting power and ground wires to the source unit.

Final Reassembly and Harness Connections

Reconnecting speedo cable and dash molex connectors.

Power Up and System Testing

Verifying the audio system operation after installation.

Audio Connections Schematic

Diagram illustrating all audio connections and wire functions.

Kawasaki MULE PRO FXR Specifications

General

Brand	Kawasaki
Model	MULE PRO FXR
Category	Stereo System
Language	English