Kawasaki Ninja 1000 Fitting Instructions

Description:
Part Number:
Model:
Assembly Time:
KIT ACCESSORY, SADDLEBAG BRACKETS (USA) (Version B)
99994-0207
Ninja 1000 (Z1000SX) 2011- (ZX1000G.., ZX1000H..)
Approx 1,5 h
Before you begin, read through these instructions and check that all parts are present.
Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect installation.
Kawasaki recommends that all genuine accessories should be fitted by an authorised Kawasaki dealer.
Apply Loctite or similar non-permanent locking agent for bolts and screws
1. Follow the steps shown in Img. 1,2,3,4,5 below to disassemble the seat (two screws), the grab rails.
Remove the four screws of the upper tail cover, pull the sides outward and remove the cover completely.
Img. 1
Img. 2
Img. 3
(Pag 1 of 5)
99994-0207
22/07/2011
KAWASAKI MOTORS EUROPE N.V.
P.O. Box 532, 23100AM Hoofddorp
The Netherlands
Fitting Instructions

Kawasaki Ninja 1000 Specifications

General

Displacement	1, 043 cc
Bore x Stroke	77.0 x 56.0 mm
Compression Ratio	11.8:1
Ignition	Digital
Front Tire	120/70ZR17M/C (58W)
Rear Tire	190/50ZR17M/C (73W)
ABS	Standard
Engine Type	Liquid-cooled, 4-stroke In-Line Four
Transmission	6-speed, return
Front Suspension	41 mm inverted fork with rebound and compression damping and spring preload adjustability
Rear Suspension	Horizontal Back-link with rebound damping and spring preload adjustability
Front Brakes	Dual semi-floating 300 mm discs. Caliper: Dual radial-mount, monobloc, opposed 4-piston
Rear Brakes	Single 250 mm disc. Caliper: Single-piston
Overall Length	2, 100 mm
Overall Width	790 mm
Seat Height	815 mm
Curb Mass	235 kg
Fuel Capacity	19 L
Maximum Power	104.5 kW (142 PS) @ 10, 000 rpm
Maximum Torque	111 Nm (11.3 kgf·m) @ 7, 300 rpm