Kawasaki VN1700 - User Manual

Assembly Instructions
Description: Tachometer, Bar Clamp Model:
VN1700 Nomad, Classic
and Classic LT
Part-Number: K53020-386 Approximate
Assembly Time:
30 min
Before you begin installation, read through the installation instructions and check to be sure all parts are
present.
If you are in doubt as to any part of the installation, please ask your authorized Kawasaki dealer to complete the
installation. Please note that Kawasaki cannot assume any responsibility for damage resulting from incorrect
installation.
Parts List Tools Required:
Seq. Part Number Description Qty.
1.
T.B.D.
Tachometer
Assembly
1
2. 99-0605 4” cable ties 3
 Cross-point screwdriver
 Small flat blade screwdriver
 Wire connector crimping pliers
 8mm Hex Socket 3/8“ drive
 Ft.lb. torque wrench
(Range minimum: 20 Ft lbs)
Installation Instructions
Tachometer Installation Preparation
Parts Removal
• Refer to the Service manual for specific information in removing
the bar clamp components if further instruction is needed.
•
Remove the two screws holding the headlight assembly and
carefully disconnect the 3-pin connector on the back of the
headlight reflector to remove the headlight, set it aside for now.
•
Remove the four chrome handlebar clamp caps and bolts and the
two clamps, being careful not to move the handlebars, see side
note.
Install Tachometer
• Apply 2-stroke oil to the threads of the clamp bolts. Place the
tachometer onto the handlebar clamp area and reinstall the four
bolts. Make sure the handlebar punch mark aligns with the lower
mating surface of the bar clamp at the rear edge. Tighten the front
clamp bolts first, and then the rear bolts.
Tighten the bolts to 34 Nm (25 Ft-lbs)
NOTE:
o There will be a small gap at the back of the clamp.
NOTICE
It is recommended that you
have an assistant stabilize the
handlebars at this point to
prevent the handlebars from
moving away from the original
position and possibly causing
damage to the fuel tank
Punch mark
aligned with
top surface of
lower clamp

Summary

Tachometer Installation Preparation

Parts Removal Steps

Details on removing headlight assembly and handlebar clamp components for access.

Install Tachometer

Handlebar Mounting and Tightening

Mounting the tachometer to the handlebar clamp and tightening bolts to specified torque.

Handlebar Stabilization Notice

Recommendation to use an assistant to stabilize handlebars during mounting to prevent damage.

Wire Routing and Connections

Routing wires, connecting tachometer wires inside headlight housing and to ignition coil.

Final Checks and Operation

Reconnecting headlight assembly, starting engine, and checking tachometer operation and lighting.

Kawasaki VN1700 Specifications

General

Brand	Kawasaki
Model	VN1700
Category	Motorcycle Accessories
Language	English