10. Lift front end of ATV in center using a jack.
With front raised and secured, install lower
shock mount with supplied M10 x 40mm bolt &
M10 locking nut (I). Bolt head facing forward.
Note: Torque requirement 30-40N.m
11. Install tie rod end positioned top of spindle.
Locate Castle nut (G) and thread into tie rod end.
Always start threads by hand at least 2 full turns.
Tighten with torque wrench & 17mm socket
Note: Torque requirement 49-59N.m
12. Install the front bumper as shown above.
Tools: Torque Wrench, 12mm Socket & wrench
Hardware: (H) (M) (N)
Note: Torque requirement 25-30N.m
13. Install rear bumper with 12mm socket and
hardware (K)
Note: Torque requirement 25-30N.m
14. Install front wheels with valve stem
facing outwards using M8 locking nuts (H). Start
threading nuts by hand minimum 2 full
rotations. After use torque wrench.
Note: Torque requirement 25-
15. Align the rear wheel with the splines and
push onto rear axle. Install washer (C) first then
castle nut (F). Tighten with 27mm Socket.
Note: Torque requirement 77-92N.m
To Next Page
Loading...
