Kayo S70 - Vehicle Assembly Procedures; Prepare Vehicle for Installation; Install Front Wheel; Install Rear Wheel

Name
Quantity
A
Dust cover
4
B
Washer
4
C
Rear guard retaining
bolt
M8*16
4
D
Steering wheel bolt
M8*30
1
Steering wheel nut
M8
1
E
Engine user’s manual
1
F
Nut
M14*1.5*H
18
4
G
Cotter Pin
4*28
4
H
Spark plug socket
1
I
Rear axle splines
2
J
Washer
Φ15*28*1.5
K
Cable tie
2
L
User’s manual
1
6.Use tool ② ③, remove the screws mouning on
the rear axle,put the vehicle on the stand for easy
installation of other accessories.
7.Put the front wheel to the steering knot with
FBJ all mounting well, use tool ①⑥ to lock the
nut and washer, then insert the cotter pin(G),,
keep the bending angle greater than 180°
Note: Torque requirement 77-92N.m
8.Align the rear wheel with the splines(I) and push
on the rear axle, with the air nozzle cap facing
outward, Use tool ①⑥ to lock the nut (F) and
washer (B), then insert the cotter pin (G), keep the
bending angle greater than 180°
Note: Torque requirement 77-92N.m
9.Insert the dust cover(A) into the positions
shown above.
10.Put the steering wheel with the steering
column, use tool①⑤③ to lock (D)
Note: Torque requirement 25-30N.m