Kayoba 002-399 - User Manual

Questions and Answers

J
jenkinsmicheleAug 3, 2025
What to do if Kayoba 002-399 Treadmill display shows E05 error?
- K
  Kelly BrownAug 3, 2025
  The E05 error on your Kayoba Treadmill indicates overload protection. This can happen if the treadmill is overloaded, or a part has fastened, putting excessive strain on the motor. You should adjust the belt. Also, check whether the motor smells or sounds overloaded, and verify if the circuit board is working properly. The circuit board could be short circuited, in that case have it checked at a service centre.
M
Mark EdwardsAug 9, 2025
Why is the display not working on my Kayoba 002-399 Treadmill?
- C
  Christopher ReidAug 9, 2025
  If your Kayoba Treadmill activates but the display remains blank, start by checking the overload protection. Ensure the power switch, overload protection, and the cord between the drive unit and voltage transformer are in good condition and properly connected. Also, verify the connection between the drive unit and the display. If these steps don't resolve the issue, the voltage transformer may be defective and require replacement.
N
Nancy SantiagoAug 15, 2025
What does E02 mean on a Kayoba Treadmill?
- A
  Anthony ShafferAug 16, 2025
  If the display of your Kayoba Treadmill shows E02 after you turn it on, you should check the condition of the motor cable and replace it if necessary. If replacing the cable doesn't solve the problem, have the motor checked at a service center. Also, check the control unit and make sure the input voltage is correct.
T
Tamara SmithAug 21, 2025
What does error E01 mean on Kayoba 002-399 Treadmill?
- Z
  zachary84Aug 21, 2025
  If your Kayoba Treadmill displays 'E01' upon activation, it indicates a fault. This could be due to a fault on the signal cable. Check that all cables between the display and drive unit are in good condition. The fault could also be in components/parts in the display or in the transformer.
M
Michael WoodAug 27, 2025
How to fix E04 error on Kayoba 002-399 Treadmill?
- K
  Kyle MurphyAug 27, 2025
  If your Kayoba Treadmill displays E04 after activation, check the signal cable to the incline motor, ensuring it's in good condition; try disconnecting and reconnecting it. Also, check the power cord to the incline motor for any damage. If the power cord is faulty, replace it, or have the incline motor checked at a service centre. The circuit board may also need replacing. You can also try pressing the LEARNING button to reprogramme.