11
8. How to ush the unit once a week to
prevent high water TDS and hardness
• Empty the ice bin and water reservoir following
instructions in Section 2.
• Fill the water reservoir with clean potable water
to MAX WATER FILL.
• Plug the unit into power.
• Press and hold Clean button for 3 seconds to
start Cleaning mode for the ushing process.
• When the ushing process is complete (the
Cleaning LED goes off), drain the water
following instructions in Section 1
6. If the Making Ice green LED illuminates but
the unit has dispensed all ice
• First, press and hold Make Nuggets button for
3 seconds to exit the Ice Making mode.
• Press and hold Clean button for 3 seconds to
start the Cleaning mode to melt the clumped
ice that blocks the infrared beam.
• Press and hold Clean button again for 3
seconds in 1 minute to stop.
• Then press Make Nuggets button once to start
making ice.
7. If ice is stuck or jammed and the unit can’t
dispense ice
• Remove the stuck ice in the dispense point
with a spoon.
• Or break the jammed ice by pressing
Clean button while you hold Dispense
Nuggets button.
• Then press and hold Dispense Nuggets button
to dispense ice.
To Next Page
Loading...