3. If the Water Level red LED ashes and the
unit stops making ice
• Fill the water reservoir with clean potable water.
4. If the Water Level red LED illuminates but
the water reservoir is full
• Unplug the unit and plug the unit into
power again.
5. If the Cleaning LED ashes and the unit
stops making ice (If this section can’t solve
your problem, please go to section 9)
• Empty the ice bin and water reservoir following
instructions in Section 2.
• Plug the unit into power.
• Fill the water reservoir with clean potable water.
• Press and hold Clean button for 3 seconds to
start the Cleaning mode.
• Unplug unit and drain the water following
instructions in Section 1.
• Plug the unit back into power
• Fill the water reservoir with clean potable water.
• To start making ice, press Make Nuggets
button once
1. How to drain water
• Unplug the unit.
• Pull the drain tubes with plugs/holders out
of the unit back and lower them to a bucket
or sink, remove the plugs/holders to release
water.
• Replace the plugs/holders and put the tubes
with plugs/holders back to the unit.
2. How to empty the ice bin and water
reservoir
• Dispense ice until no more ice comes out of
the ice dispense point.
• Unplug the unit and let the remaining ice melt.
• Drain water following instructions in Section 1.
CAUTION
Use food grade citric acid powder and
chlorine bleach only.
Follow the product instructions carefully for
First Aid.
Keep them out of reach of children.
DISPENSER CARE
10
To Next Page
Loading...