Need help?Do you have a question about the KBC WESII Series and is the answer not in the manual?
General| Brand | KBC |
|---|---|
| Model | WESII Series |
| Category | Network Hardware |
| Language | English |
Instructions and information on safety, approvals, and regulatory compliance.
Lists IEEE standards, frequency bands, and radio specifications for WESII.
Details antenna types and their beamwidth specifications.
Covers system, mechanical, environmental, connectors, and approvals.
Instructions and diagrams for pole and wall mounting WESII units.
Explains power connections for non-PoE WESII units using a Power Injector Module (PIM).
Describes power connections for PoE WESII units using a PoE switch.
Step-by-step guide to set up a basic point-to-point link for US/Canada.
Detailed steps for configuring the Host unit in a US/Canada point-to-point setup.
Steps to configure the Host for point-to-multipoint in US/Canada.
Steps to configure the Client for point-to-multipoint in US/Canada.
Steps to configure the Host for point-to-multipoint in EMEA.
Steps to configure the Client for point-to-multipoint in EMEA.
Steps to configure the Host for point-to-multipoint in Australia.
Steps to configure the Client for point-to-multipoint in Australia.
Importance of proper line-of-sight, including Fresnel Zone, for wireless transmission.
Steps for aligning WESII units for optimal signal strength (RSSI).
How to access the WESII GUI via Ethernet for non-PoE and PoE units.
Configures automatic reboots based on IP connectivity loss.
Procedures for upgrading the WESII firmware.
Procedure to restore WESII units to default configurations using the reset button.
Setting LAN IP, subnet mask, and Gateway IP via static or DHCP.
Details Host/AP and Client basic wireless configuration parameters.
Client connection frequency and interference detection tool.
Settings for links exceeding 1.6km/1 mile and adjusting RSSI LED values.
To Next Page