kbice FDFM1JA01 Quick Start Guide

Name: kbice FDFM1JA01
Brand: kbice
Rating: 4 (1 reviews)

2 pages

To Next Page

This unit requires purified or distilled water,

which significantly improves the ice quality

and ice making performance. Water with a

TDS or hardness of <100 PPM is also

acceptable. Water with over >100 PPM will

cause the unit to go into "Clean” Mode

frequently and not produce ice.

TDS

Self-Dispensing Nugget Ice Maker Dispenser

QuickStart Guide — Model: FDFM1JA01

INSTALLATION

Clearance Requirements

CAUTION

This unit is designed for household countertop use

only.

Never block the air vent on the left side.

The unit operates in an area with a maximum

ambient temperature of 85°F. Therefore, the warmer

ambient temperature will result in reduced ice

capacity and quality.

Never operate this unit in direct sunlight.

Allow for a minimum clearance of 4 inches on both

left and right sides, 2 inches on the back, and ½ on

the top to ensure the proper functionality of the unit.

Scan here for instructional video:

Electrical

Requirements

DANGER

This unit requires that you connect only to a

GFCI protected receptacle.

Strongly advised that you do not use an adapter

to connect this unit because of safety hazards.

A dedicated 120V, 60Hz, 15A fused, grounded

electrical supply is required.

Water

Requirements

1. Display Panel

2. Ice Dispense Point

3. Water Fill Port

4. Air Vent

5. Water Drip Tray

6. Power Cord

7. Drain Tube Plugs/Holder

Call or Text “Help” 800.433.9938 | info@kbgoodice.com | www.kbgoodice.com

Other manuals for kbice FDFM1JA01

User Instructions16 pages

Service Instructions30 pages

Questions and Answers:

S
Sherry LeeAug 7, 2025
Why is my kbice Ice Maker not making ice?
- I
  ipetersenAug 7, 2025
  Your kbice Ice Maker might not be producing ice for several reasons. First, ensure the ice maker is turned on by pressing the Make Nuggets button once. Also, check that the clearances are adequate and the ambient temperature meets requirements. If the Water Level red LED flashes quickly, refill the water reservoir with clean, potable water. If the unit has dispensed all ice, press and hold the Make Nugget button for more than 10 seconds to restart ice production. If the Clean LED flashes quickly, initiate defrosting by pressing and holding the Clean button for over 3 seconds. If all LEDs flash simultaneously, drain the unit and plug it back into power. If none of these steps work, the water pump, water level sensor, ice engine motor, or cooling system may be defective, requiring service.

kbice FDFM1JA01 Specifications

General

Brand	kbice
Model	FDFM1JA01
Category	Ice Maker
Language	English