This unit requires purified or distilled water,
which significantly improves the ice quality
and ice making performance. Water with a
TDS or hardness of <100 PPM is also
acceptable. Water with over >100 PPM will
cause the unit to go into "Cleaning” Mode
frequently and not produce ice.
KBice Self-Dispensing Nugget Ice Maker Dispenser
QuickStart Guide — FDFM1JA02
INSTALLATION
Clearance Requirements
This unit is designed for household countertop use
only.
Never block the air vent on the left side.
The unit operates in an area with a maximum
ambient temperature of 85°F. Therefore, the warmer
ambient temperature will result in reduced ice
capacity and quality.
Never operate this unit in direct sunlight.
Allow for a minimum clearance of 4 inches on both
left and right sides, 2 inches on the back, and ½ on
the top to ensure the proper functionality of the unit.
Scan here for instructional video:
Electrical
Requirements
This unit requires that you connect only to a
GFCI protected receptacle.
Strongly advised that you do not use an adapter
to connect this unit because of safety hazards.
A dedicated 120V, 60Hz, 15A fused, grounded
electrical supply is required.
Water Requirements
(The funnel is located inside the reservoir)
Call or Text “Help” 800.433.9938 | info@kbgoodice.com | www.kbgoodice.com
To Next Page
