8.Loosen and remove the 3 brass light kit
screws pre-locked on the lamp
panel(They will be needed later)
10.Align the screw holes and tighten
the 3 brass light kit screws
12.Loosen the 2 brass screws pre-locked on
the top of the motor
11.Turn the fan over
9.Connect the light source with the wires
from the motor
7.Tighten the 3 silver lamp panel screws
14.Remove the lock pin and the bolt of
the base of the downrod
13.Remove 2 screws on the hanger ball
To Next Page