Carefully remove your P14 from its shipping carton and locate the enclosed
accessories:
• AC power cord
• A 12V trigger wire for auto turn on. It has a mono 3.5 mm mini plug at each
end.
While you are unpacking your P14, inspect it thoroughly for possible shipping
damage and tell your KECES dealer immediately if you find any evidence of
shipping damage. This would be a good time to make a copy of your sales
receipt to store with the P14’s original packing.
Note:
Please save and store both the inner and outer cartons and, most especially,
the foam packing inserts to protect the P14 if you have to move it or ship it. You
may wish to flatten the cardboard cartons to save room in storage after cutting
the taped seams on the bottom flaps.
--------------------------------------------------------------------------------------------------------
Placement Guidelines
The P14 will be easier to use and will last longer if you follow these simple
guidelines:
• Place the P14 on a surface that will adequately support its weight.
• Use input and output cables that are long enough to leave some slack; that will
enable you to pull the P14 out of a cabinet to check or to change connections
without inadvertently disconnecting cables.
• The P14 should never be placed in a completely enclosed cabinet.
Ventilation Requirements
• Always position the P14 horizontally.
• The P14 should never be stacked directly above another power amplifier and
power supply or directly below another component.
• Do not install the P14 in an unventilated equipment cabinet or compartment.
Pockets of stagnant hot air can build up even in a cabinet with an open front
and back. A ventilation fan is recommended to prevent “hot spots” in confined
spaces.
To Next Page
Loading...
