Make sure the 115V/230V Voltage Selector switch on the P14 bottom plate is set
for the correct Ac line(mains) voltage before you plug in the power cord. It can
be seriously damaged if this switch is set for the wrong AC mains voltage.
In the 115V position the P14 can safely operate with AC Line voltages between
110-125V which is correct for North America, Mexico, and Taiwan. In some
countries, such as Brazil, AC voltages differ by region. Most other countries
require setting it to 230V. With the 230V setting the P14 can operate safely with
AC line voltages between 220-250V. If the AC Voltage Selector is changed the
rear panel fuse value must also be changed. The P14 operates on 50Hz or 60Hz
AC.
Note:
An P14 that has been damaged by connection to the incorrect AC mains
voltage is not covered by the KECES warranty.
--------------------------------------------------------------------------------------------------------
AC Power Cord
The AC cord supplied with your P14 is a high quality IEC type cord. Please
connect it directly to an AC wall outlet or power conditioner that is always “live.” If
possible, plug your P14 and other components, (including a TV or video
projector) the ground potential may be higher or lower between the outlets,
resulting in audible hum.
To Next Page
Loading...
