KEF Ci3-80QT - Open Position Adjustment; Ci200.3 QT Specific Notes; Motor Speed Compatibility

For the open position:
These images show how the “lower” limit switch as it should be adjusted.
Motion of the housing should stop when the little roller is about half way up the
ramp. This adjustment may require a small bend to be made in the switch lever.
We do this by grabbing the metal tab just behind the roller with needle nose
pliers and just putting a small bend in the tip of the lever.
Ci200.3QT Notes:
The quite motor in the Ci200.3QT version moves more slowly than the motor in the
Ci200.2QT so these models should not be mixed in the same installation.
www.KEF.com