19
Bottom lift distance（mm）： Recommended value 12, print the bottom of
the stripping height.
Lift distance（mm）： Recommended value 10, lifting height of demoulding
for common layer.
Bottom lift speed（mm/min）： Recommended value 80, bottom drawing lifting
speed.
Lifting speed（mm/min）： Recommended value is 80, lifting speed of
demoulding for common layer.
Retract speed（mm/min）： The recommended value is 300, the motion speed
of z-axis decline.
6、Support parameter setting
Click "import parameters" → select the Slicer of the U disk "select
s400s_supposition. CFG" → "open". The following figure is the final
parameter setting.
To Next Page