To Next Page

To Previous Page

MODE 1 2 3

Functions (# User Settable)

# Selectable pressure units kPa or psi Y Y Y

# Start-up timer, fully adjustable and self terminating Y Y Y

# Run-on timer, fully adjustable and self terminating Y Y Y

# Delayed re-starting timer, once stopped delays the restart Y

# Batch control, sets a specic run time for the pump Y

# Auto restart if run dry, both single and multiple attempts Y

# Trip pressure, fully adjustable and can be turned on or off Y Y

# Snap pressure, allows the setting of a single switch point Y

# Snap pressure switching differential (delta pressure) Y

# Starting pressure, fully adjustable and can be turned off Y Y

# Stopping pressure, fully adjustable and can be turned off Y Y

# Anti-cycling controls the number of motor starts per hour Y Y

# Anti-cycling sensitivity control to avoid nuisance tripping Y

# Start the pump at a preset low pressure Y Y Y

# Stop the pump at a preset high pressure Y Y Y

# User can congure the E30’s output to be relay 1 or relay 2 Y

# User can congure the E30’s output relay to be NO or NC Y

# Start & stop a pump using an external low voltage switch Y Y Y

Displays the system’s pressure in preferred units, kPa or psi Y Y Y

Displays the high & low pressure set points in preferred units Y Y

Displays the snap pressure point in preferred units Y

Displays a warning if you enter incorrect pressure settings Y Y

Displays the reasons for faults and alarms on its LCD screen Y Y Y

Over pressure alarm automatically invoked at 22 Bars Y Y Y

# Alarm relay can be set to close on 1 of 7 specic conditions Y Y Y

E30 Modes and Functions

KELCO E30 Programming Instructions

Other manuals for KELCO E30