Specification and Operating Instructions
KLT11-D Temperature Digital Controller
Description
Installation
NOTE: Unit must be mounted away from vibration, impacts,
water and corrosive gases.
Cut hole in panel 2.80 x 1.14 inches)
Apply silicone (or rubber gasket) around the perimeter of
the hole to prevent leakage.
Insert unit into hole of panel.
Slide removable fitting clips onto unit from the back until
secure to panel.
Wiring diagram is displayed on the top of the unit
NOTE: DO NOT INSTALL PROBE CABLE NEAR POWER
CABLES.
The KLT11 is designed for many heating and cooling
applications. It has an input for temperature probe type PTC
or NTC The probe temperature is
displayed on the bright 3-digit display. The user is able to
program 16 different parameters including set point,
hysteresis, cycle time and ambient probe adjustment using
the silicone front keypad. The KLKey input allows an easy
programming of the parameters. The unit features error
warning and password protection. Select between red,
green or blue display color, temperature display in ºC or ºF
and 115Vac, 230Vac, 24Vac/dc or 12Vac/dc power supplies.
The model reference is given by: KLT11 - DWXYZ
Where each sufix can take the following values:
==
X Display Color R=Red, G=Green, B=Blue
Y Supply Voltage 110=115Vac, 230=230Vac
24=24Vac/dc, 12=12Vac/dc
Z Units C=ºC, F=ºF
•
•
•
•
•
(selectable by parameter).
Model references
W Output Null 16A(1HP), 2 20A(2HP)
71 x 29 mm (
Technical Data
Supply voltages
115Vac±10%, 230Vac±10%, 24Vac/dc±10%, 12Vac/dc±10%
Supply powers
4VA (230V/115V) 1,5VA(24V /12V)
1% of full scale
0,1º (3 digits)
Display
3-digit and sign (red, green or blue)
Output
1HP Model SPDT Relay Resistive load 16A
1HP 240Vac -- 10FLA, 60LRA 240Vac
2HP Model SPST Relay Resistive load 20A
2HP 240Vac -- 12FLA, 72LRA 240Vac
Dimensions
Front 77 x 36 mm Depth 62 mm (3.03 x 1.42 x 2.44 inch)
Front Protection IP64
Storage temperature
-20ºC to 80ºC (-4 to 176ºF)
Operating temperature
0ºC to 70ºC (32 to 158ºF)
Probe range
PTC -50ºC to 150ºC (-58 to 302ºF)
NTC -50ºC to 110ºC (-58 to 230ºF)
Accuracy
Better than
Resolution
Probe Input (Selectable by parameter)
PTC1000 probes (25ºC - 1000 Ohm) / NTC
KLKey Input
For an quick programming of all parameters
Wiring Diagram
To Next Page
Need help?
General
