4
choose 6to check vehicle tare
show store space usage percentage(store number/1000)
show first vehicle number
show the checked vehicle tare
still show first vehicle number
Mark:step 6 and 7:Press【CLEAN】,clear this vehicle tare; Press【←/→】,check the front and back vehicle tare.
3.4．Print of weighing record
1． Printing parameter must be set correctly before printing. (Refer to the part of printing parameter setting
of technical manual)
2． The storing and printing of the indicator are simultaneous. At the same time when a group of complete
record is stored with【SAVE1】or【SAVE2】, it will be printed out. (If the printing setup is effective, namely
the model of the printer is non-zero and printing while storing is selected)
3． If the weighing record is not printed successfully because of some reason (ex.: printer fault), after the
fault is eliminated, press【REPRINT】and print the record stored currently.
4． In the end of a period of weighing, may press【A.P】to print out the accumulated value.
5． If press【SAVE2】and use the two-time storage (loaded after empty, or empty after loaded), during the
first storing, because the record is not completed, the indicator displays【LoAd】for 1.5 seconds but does not
print. However, if press【REPRINT】at this time, the incomplete record can still be printed out. The printing
result is as below:
① Serial number is 0;
② Gross weight and net weight are all 0;
③ Tare weight is the weight value displayed currently.
3.5 Statistical form printing
Parameter or
Function Code
Paremeter or Function Type
Detail Form in Certain Date
Detail Form during Certain Period
Detail Form for Certain Vehile No.
Detail Form for Certain Cargo No.
1. Total detail list Form
Begin printing the form. Back to the weighing
status after printing
2.Some day detail list form
press“01”， choose some day detail list form
Begin printing the form. Back to the weighing status
after printing
3.Some time detail list form
To Next Page
Loading...