PRE-OPERATIONAL INSPECTION
WARNING: Remove the key from the ignition prior to any engine check or
operation. Do not energize any engine prior to performing any of the following.
Your KODIAK Marine Engine was inspected and test run before leaving the factory. Before
operating a new engine, you must follow any pre-operational instruction.
1. Open the engine hatch cover to let the compartment air out for at least ten minutes.
2. Always make sure you are working in a well-ventilated area when around gasoline.
3. Check engine oil level, remove dipstick wiping clean and recheck your oil level.
4. Inspect the oil and fuel filters for tightness and making sure there are no leaks around these
filters.
5. Check coolant level – refill to the appropriate levels.
6. Check for any oil, coolant or fuel leaks.
CAUTION: Follow any leaks and repair any abnormal leakage before continuing.
7. Inspect the battery connections for corrosion, clean as necessary
8. Check the battery fluid level and state of charge, fill as needed.
9. Inspect the spark arrester for any obstructions (Bugs, leaves etc.,) clean or replace as
needed.
10. Check coolant Hoses for Leaks (follow any leaks and repair)
NOTE: It is suggested to use Baking Soda and water to safely clean any corrosion
around the Battery connections.
NOTE: If the engine is equipped with a stern or jet drive it must be in neutral prior to
starting the engine. Starting the engine with the drive engaged imposes unnecessary
strain on the battery, starter and driven components.
14
To Next Page
Loading...
Need help?
General
