Kemao KM35 Series User Manual

Km35 Series Drinking Fountains /Water Coolers
INSTALLATION, CARE & USE MANUAL
Page 1 (Rev. A - 6/2012)
To insure you install these models easily and correctly, PLEASE READ THESE
SIMPLE INSTRUCTIONS BEFORE STARTING THE INSTALLATION. CHECK
YOUR INSTALLATION FOR COMPLIANCE WITH PLUMBING, ELECTRICAL, AND
OTHER APPLICABLE CODES. After installation, leave these instructions with the
Fountain for future reference.
IMPOR TANT
THIS IS AN INDOOR APPLICATION ONLY.
ALL SERVICE TO BE PERFORMED BY AN
AUTHORIZED SERVICE PERSON.
IMPORTANT! INSTALLER PLEASE NOTE.
THE GROUNDING OF ELECTRICAL EQUIPMENT SUCH AS TELEPHONE, COMPUTERS, ETC. TO WATER LINES
IS A COMMON PROCEDURE. THIS GROUNDING MAY BE IN THE BUILDING OR MAY OCCUR AWAY FROM THE
BUILDING. THIS GROUNDING CAN CAUSE ELECTRICAL FEEDBACK INTO A FOUNTAIN, CREATING AN ELEC-
TROLYSIS WHICH CAUSES A METALLIC TASTE OR AN INCREASE IN THE METAL CONTENT OF THE WATER.
THIS CONDITION IS AVOIDABLE BY USING THE PROPER MATERIALS AS INDICATED. ANY DRAIN FITTINGS
PROVIDED BY THE INSTALLER SHOULD BE MADE OF PLASTIC TO ELECTRICALLY ISOLATE THE FOUNTAIN
FROM THE BUILDING PLUMBING SYSTEM. WE SUGGEST THAT THE BOTTLE FILLING STATION AND WATER
COOLER BE PROTECTED BY A GROUND FAULT CIRCUIT INTERRUPTER (GFCI).
TOOLS REQUIRED
BUT NOT PROVIDED:
SAFETY GLASSES
GLOVES
1-3/8"HOLE PUNCH (PROVIDED)
1/2"DRILL BIT
ELECTRIC DRILL
3/4"WRENCH OR CRECENT WRENCH
5/16"NUT DRIVER
UTILITY KNIFE
TAPE MEASURE
PENCIL
CENTER PUNCH
1/2"SOCKET & RATCHET WRENCH
5/32"ALLEN WRENCH
KEMAO
R

Kemao KM35 Series Specifications

General

Brand	Kemao
Model	KM35 Series
Category	Water Dispenser
Language	English

Summary

General Installation and Safety

Important Installation Precautions

Covers indoor application, authorized service, tools, grounding, electrolysis, plastic fittings, GFCI, and code compliance.

Required Tools List

Lists tools needed for installation that are not supplied with the unit.

Installation Dimensions and Connections

Mounting Bracket and Unit Positioning

Details on hanger bracket fixing, unit hanging, and clearance requirements for ventilation.

Water and Drain Connection Points

Identifies specific locations for water inlet, ice bank fill, waste outlet, drain trap, and water supply valve.

Hanger Bracket and Cooler Mounting

Hanger Bracket & Trap Installation

Instructions for mounting the hanger bracket to the wall and maintaining trap dimensions.

Installation of Cooler

Steps for hanging the cooler onto the mounted bracket and removing the front panel.

Water and Drain Connections

Water Connection to the Main

Details on mains water pressure, pressure reducers, tube connection, and water supply valve.

Filling Internal Ice Bank

Steps for connecting the water supply to fill the ice bank and managing overflow.

Drain Connection

Instructions for connecting the drain pipe to the tray and drain trap.

Cleaning and Maintenance

Cleaning Instructions

Guidance on using mild cleaning products for exterior panels and avoiding harsh chemicals.

Service and Maintenance Procedures

Lower and Upper Shroud Removal

Instructions for removing shrouds to access internal components like refrigeration and plumbing.

Bubbler Servicing

Steps to remove and service the bubbler, including disconnects and locknut adjustment.

Switch Operation

Switch Activation Details

Illustrates open and closed switch states and notes on push activation methods.