Why is my Kemper Construction Equipment aerator dripping?
The aerator might be dripping because the solenoid valve isn’t closing properly. Try removing the solenoid valve and cleaning it, replacing it if necessary.
What to do if there is an odour from my Kemper Construction Equipment?
If you notice an odour, it could be due to a lack of water in the trap. Perform a manual flushing. Alternatively, the anti-siphon trap might not be fitted correctly; ensure it is properly installed.
How to fix a Kemper Construction Equipment reversible cover that doesn’t close flush with the wall?
If the reversible cover doesn’t close flush with the wall, it could be due to several reasons: * The magnetic safety catch might not be installed correctly, or only one of the catches moved. Install the magnetic safety catch correctly and ensure both catches are in the same position. * There might be plaster residue in the frame. Remove any plaster residue from the frame. * The guide bolts under the reversible cover might not be inserted in the holes provided in the FM frame. Insert the guide bolts into the appropriate holes.
What to do if the float switch triggers a fault signal in my Kemper Construction Equipment?
A fault signal from the float switch could indicate backflow in the connected drainpipe or trap due to clogging. Check whether the drainpipe was designed according to DIN 1986-100 in conjunction with EN 752 and EN 12056. Manually check the float switch and also check the cable connection from the float switch to the controller.
How to fix no water from Kemper Construction Equipment aerator?
If there's no water coming from the aerator, it might be because the FL is installed the wrong way round. Ensure you install the FL correctly, with the aerator’s outer gasket pointing in the direction of flow (upwards).
How to fix no clean spray cone from Kemper Construction Equipment aerator set?
If you're not getting a clean spray cone from the aerator set, it could be due to calcification of the FL or aerator. Try cleaning the FL/aerator, and replace it if necessary. It also may be caused by non-compliance with the recommended replacement interval or clogging.
General| Power Supply | 24V DC |
|---|---|
| Operating Temperature | 5 - 40 °C |
| Flush Time | Adjustable |
| Flush Interval | Adjustable |
| Connection | 1/2" BSP |
| Flush Volume | Adjustable |
| Water Connection | G 1/2" |
To Next Page
