EasyManua.ls Logo

Kenmore 110.65132410 - User Manual

Kenmore 110.65132410
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Use & Care Guide
Manual de uso y cuidado
Guide d’utilisation et d’entretien
English / Español / Français
Table of Contents / Índice / Table des matières......4
Kenmore®
Electric or Gas Dryer
Secadora eléctrica o a gas
cheuse électrique ou à gaz
Models/Modelos/Modèles: 110.65132410, 110.75132410, 110.C65132410, 110.65232610, 110.75232610, 110.C65232610
P/N W10884808A
Sears Brands Management Corporation
Hoffman Estates, IL 60179 U.S.A.
www.kenmore.com
Sears Canada Inc.
Toronto, Ontario, Canada M5B 2C3
www.sears.ca

Questions and Answers

  • A
    Ashley CruzAug 14, 2025
    Why are my clothes not drying properly in my Kenmore 110.65132410?
    • D
      Douglas LawrenceAug 14, 2025
      There are several reasons why your clothes may not be drying properly. The lint screen could be clogged and needs cleaning before each load. You may have selected the 'Air Only' cycle instead of a drying cycle appropriate for your load. The load might be too large, preventing proper tumbling. The exhaust vent or hood could be blocked, restricting airflow; clean the vent or replace it with a metal one, ensuring it's not crushed or kinked. Too many fabric softener sheets can block the grille, so use only one sheet once. An exhaust vent that is too long or the wrong diameter can also extend drying times; use a 4" diameter vent material. Finally, ensure the dryer is in a room above 45ºF (7ºC) and, if in a closet, that there are adequate ventilation openings.
  • Y
    yhansonAug 17, 2025
    What to do if my Kenmore 110.65132410 Dryer will not start?
    • J
      Jimmy JohnsonAug 17, 2025
      If your Kenmore Dryer isn't starting, first ensure the door is fully closed. Then, press and hold the 'PUSH TO START' button firmly until you hear the drum moving. Check your household fuses or circuit breakers, as electric dryers need two; replace both fuses or reset the breaker. If it continues, contact an electrician. Confirm your dryer has a 240-volt power supply, and that you're using a time-delay fuse.
  • R
    Richard DavisAug 21, 2025
    Why is my Kenmore 110.65132410 not heating up?
    • R
      rdanielsAug 21, 2025
      If your Kenmore dryer isn't producing heat, start by checking your household fuses or circuit breakers, as electric dryers use two. Replace both fuses or reset the circuit breaker. If the issue persists, contact an electrician. For gas dryers, ensure the supply line valve is open. Electric dryers require a 240-volt power supply, so verify this with a qualified electrician.
  • A
    aatkinsAug 25, 2025
    Why does my Kenmore 110.65132410 make unusual noises?
    • X
      xsanchezAug 25, 2025
      Unusual sounds can occur for several reasons. If the dryer hasn't been used recently, a thumping sound may appear during the first few minutes. Check for any objects like coins or buttons caught between the drum and the dryer's front or rear. If it's a gas dryer, the clicking of the gas valve is normal. Ensure the dryer is properly installed with all four legs and is level. Also, check if clothing is knotted or balled up, and separate items to allow free tumbling.
  • E
    Erica Payne PhDAug 27, 2025
    How to prevent lint on clothes from my Kenmore 110.65132410 Dryer?
    • D
      davisdarrenAug 27, 2025
      To prevent lint on your clothes, ensure you clean the lint screen before each load.
  • C
    Caitlin JonesAug 30, 2025
    How to prevent wrinkles in my Kenmore 110.65132410 Dryer?
    • N
      Nathan HughesAug 30, 2025
      To reduce wrinkles, promptly remove the load at the end of the cycle. You can also select the Wrinkle Guard™ option to tumble the load without heat. Make sure you are drying smaller loads that can tumble freely.
  • G
    grosscynthiaSep 3, 2025
    Why is the cycle time too short on my Kenmore Dryer?
    • G
      Gregory CareySep 3, 2025
      If the automatic cycle is ending too early, the load may not be contacting the sensor strips. Try leveling the dryer. For very small loads, use Timed Dry. You can also adjust the dry level setting on Auto Moisture Sensing™ cycles to increase drying time.
  • A
    Ashley HallSep 6, 2025
    Why are my clothes too hot after using my Kenmore 110.65132410 Dryer?
    • H
      hochoaSep 7, 2025
      If laundry items are too hot, allow the cool down to finish before removing them from the dryer. Also, avoid using high-temperature cycles or settings. Select a lower temperature and use an automatic drying cycle, which senses the temperature or moisture level and shuts off when the load reaches the selected dryness.
  • D
    Dakota ClineSep 9, 2025
    Why does my Kenmore 110.65132410 smell?
    • J
      Jennifer DorseySep 9, 2025
      If you've recently been painting, staining, or varnishing near the dryer, ventilate the area, and then rewash and dry the clothing. If it's a new electric dryer, the heating element may have an odor that will disappear after the first cycle.

Summary

Dryer Safety

Understanding Safety Symbols

Explains the safety alert symbol and terms like DANGER and WARNING.

Fire Hazard Precautions

Details precautions to mitigate fire risks associated with dryer installation and operation.

Important Safety Instructions

General Usage Precautions

Provides essential safety measures for operating the dryer, preventing fire, shock, and injury.

Gas Leak Response

Outlines immediate actions to take if a gas leak is suspected to ensure safety.

Auto Moisture Sensing Cycles for Better Fabric Care and Energy Savings

Auto Moisture Sensing Cycles Explained

Explains how Auto Moisture Sensing cycles optimize drying based on moisture levels for better fabric care and efficiency.

Cycle Guide - Auto Moisture Sensing Cycles

Auto Moisture Sensing Items to Dry

Provides guidance on selecting dryness levels and temperatures for various fabric types in Auto Moisture Sensing cycles.

Using Your Dryer

Safety Warnings for Use

Highlights critical safety warnings related to flammable materials and oil residue to prevent hazards.

Prepare Dryer: Clean Lint Screen

Details the process of cleaning the lint screen before each load to ensure proper dryer function.

Dryer Care

Cleaning Lint Screen (As Needed)

Explains how to wash the lint screen to remove residue buildup and maintain efficiency.

Troubleshooting

Clothes Not Drying; Drying Times Too Long

Addresses common issues like poor drying performance and long drying times with potential causes and solutions.

Dryer Will Not Run

Helps diagnose and resolve problems where the dryer fails to start or operate.

No Heat

Provides troubleshooting steps for the common problem of the dryer not producing heat.

Kenmore 110.65132410 Specifications

General IconGeneral
BrandKenmore
Model Number110.65132410
Capacity7.0 cu. ft.
ColorWhite
Voltage240 V
Width29 inches
Weight120 lbs
Number of Cycles12
Number of Temperature Settings4
Wrinkle Guard OptionYes
End-of-Cycle SignalYes
Lint FilterYes
Energy Star CertifiedNo
Control TypeElectronic
TypeDryer
Depth28 in.
Drying CyclesHeavy Duty, Delicates, Normal
Amperage30 A
Height43 inches

Related product manuals