PICKnNG UP BOBBIN THREAD
Raise presser foot lever, Hold needle
thread loosely in left hand and rotate
handwheel toward you one complete
turn.
®
2. Bring bobbin thread up by pulling
upper thread,
3_ Pull both threads under and to the
back of the presser foot, leaving 3 to
4 inches of thread clear°
If you cannot pick up bottom thread by
following steps given above, then check:
1, ls needle threaded from front to back?
2, Is thread tangled around needle?
3. Is there 3 to 4 inches of thread coming
from the bobbin case?
4. Is thread from bobbin case tangled?
15
To Next Page