ADJUSTING BUTTONHOLE
STITCH BALANCE
If the stitching on both sides of the
buttonhole does not have the same
density, adjust-by turning the adjuster.
Using a screw driver, make a slight
adjustment to left (+) increase the density
of the left side; turn to the right (-) to
increase the density of the right side.
Both sides should be similar in appea-
rance.
After sewing buttonholes, return adjuster
to original position as shown in illus-
" tration at left.
SHELL STITCHING AL_j__/__iAL
SETTINGS
StitchSelector ........ _
StitchLength Control . .. 18
Zigzag PresserFoot
When sewing this stitch, allow needle to
just clear the right edge of the fabric
when it zigzags.
NOTE:
You may need to increase your tension
slightly to achieve the shell affect.
3O
To Next Page