Follow these easy steps to get started with your Kenmore air purifier.
Please be sure to read the Use & Care Guide prior to using your air purifier.
quick start guide
1500e Series Air Purifier
SET UP YOUR AIR PURIFIER
UNDERSTAND YOUR AIR PURIFIER
1
Place the air purifier on a level surface.
Remove the filter doors on both sides of
the air purifier by pulling on the clasp of
the doors.
WARNING
Before first use, remove filters from unit and discard protective filter packaging.
2
Remove the packaging from both filters
and then re-insert the filters back into the
air purifier.
IMPORTANT: Do not run the unit without
removing the packaging from the filters.
4
Position the unit on a level surface and
away from anything that would block
airflow (ex: curtains).
Tap On/Off Button to turn on/off the air purifier.
Tap the Mode button to switch the air purifier into AUTO mode,
SLEEP mode or Manual mode. The corresponding light will turn on
to indicate the mode.
Fan speed audomatically adjusts as your air quality changes.
Sleep Mode - the fan will run at the lowest fan speed and the
display screen turns off. To exit this setting, press any button.
Or Visit
kenmorefloorcare.com
/1500e-series/
for full product instructions
or to purchase replacement filters
5
Insert the power adapter into the power
port on the back of the air purifier. Plug
the power cord into an electrical outlet
and tap the Power Button to turn on
the unit. The unit will enter into AUTO
mode.
3
Once the filters are reinstalled, install the
filter doors back into place. See visual
description below.
Slots
Locking
Tabs
Tap the Fan Speed button to manually choose between 5 fan
speeds.
Set a timer.
Child Lock - to activate or deactivate, hold down the 'Mode' and
'Fan Speed' buttons simultaneously for more than 3 seconds.
When the last frame of filter life indicator flashes, press and hold
the Filter Reset button for more than 3 seconds to reset the filter
meter after installing new filters.
SCAN HERE
Power Port
To Next Page
Need help?
General
