2. StitchWidthControt
[IN
3÷
/
Stitch Length Controt
Stitch Seiector
"_5. Reverse Stitch Lever
This control regulates the length of the
stitch you select. _ i
The diaf is calibrated in stitches per inch.
The higher the number, the shorter the
stitch.
Fabric will not be fed when the dial is set at
"0 't"
The desired stitch will be obtained by
turning this Stitch Selector until the stitch
is indicated by the red line on the indicator
panel.
Note: To select a stitch, be sure needle :is
out of fabric at its highest position.
When reverse stitching iS needed, push down the lever and
hold there during sewing.
To Next Page
