i| i i i l Jm
FLi_ DDG }.i]Gh=
REVISED
St€
| PAG| I
i. Ba_se the fecd dogs tc the highest Feslt_on by
t_rnln._ the han_.whcel toward you.
2. Chcck tc see whether the tips of the feed dog
teeth are at the height wlthin 0.9-1.1rr above
the u_er suzface of the needle _late.
!
,,_ _, _,
G= $ :,!
G_ .,G! *,riO.! €1_,1)$
_&tLP*&t|
ADJU£TM£!_T
I. _er:ve the bettor coy{-.
2. Ealse the feed doqs to the hagheLt pos,tlor, by
turnzng the har,dwLeel toward you.
3. AJ)ust th_ h[i_ht of the f_'ed dou_ by loes{r, ln';
the nut(1) sllghtly and tuzn_ng the screw(2)
In e_th_r way.
4.':_ghten the nut _ecurely afte_ ad]ustment.
2
I
i I
ZEPO £EIDIr:G
., . ...
REVIS[D
ml Ill
s_c ; 1 - ?
I
t Om6,_,AL Ma_',E4
CNLCK]NG
i. Set the stitch length control at zero.
2. Place a sheet of paper under the presser foot
ar,d rotate the_handwheel toward you eleven tir.es
_anuall¥. Exan._ne the needle h01e(s) perfozated
on the paper. A single Or two needle holes
are acceptab*e as Illustrated below _or the
correct zero _e_ positioning.
ADJU_TMEhT
i. Be_ve the botto_ cover.
2. Turn the screw(1) on the feud regulatin_
arF(2) untll zero feed is obtained.
I-
• _ i i , ,m, iii
To Next Page
Loading...
