GETTING READY TO SEW
SETrlNG UP YOUR MACHINE
When you open your Kenmore carton, you'll find the basic machine,
foot control, the instruction book you now are reading, and one box
of attachments {Accessories end ButtonholerL Set your machine on a
sturdy flat surface. Be sure to wipe off any excess oil that may have
accumulated in shipping,
Step 1: The spool pins
You'tl find Spool Pins (32) packed in
the Accassones and Buttonholer
Box. Using a screwdriver, attach
them securely at rear as indicated.
Step 2: The electrlclty
Plug Foot Controt {46) into Cord
Connection {26). Then, connect cord
into any 110-120 volt wall outlet.
Important safety notes
Your machine will not operate unless
the Power/Light Switch (28) is
turned on. This same switch controls
the machine power, sewing light, the
indicator lights on the stitch selection
panel (20) and needle controls (24
and 25). If you are interrupted or stop
sewing, turn off the switch-this is an
important safety feature that
prevents accidents.
!llt_ i
To Next Page
Loading...
