installing Your Freezer
• Thisappliance is designed to be free standing only,and should not be recessed or
built-in.
o Place your freezer on a floor that is strong enough to support the freezer when it is
fully loaded.
• Allow ,5.9inches(1,5cm) of space between the back and sides of the freezer, which
allows for the proper air circulation.
• Locate the freezer away from direct sunlightand sourcesof heat (stove,heater,
radiator, etc.). Direct sunlight may affect the acrylic coating and heat sources may
increase electrical consumption. The recomended operating ambient temperature
should be between 55°F(12.8°C) and 110°F(43.3 )°C.
® Avoid locating the freezer in moist areas.
• Removeshipping material including base
Cut the packaging strap, thentake off the packaging box and the interior protective plastic
bag. Removethe protective foamsoff the freezer and put them insidethe upended
packaging box, uplift the freezer and remove the bottom protective pad under the
freezer.
o After plugging the appliance into a wall outlet, allow the unitto cool down for 2-3
hoursbefore placing food inthe freezen
Electrical Connection
WARNING
Improper useof the grounded plug can result in the riskof electrical shock. If the power
cord is damaged, have it replaced by anauthorized Avanti Products service centen
Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not
under any circumstances cut or remove the third (ground) prong from the power
cord. Any questions concerning power and/or grounding should be directed
toward a certified electrician.
To Next Page
Loading...
