1. Determine whether hood will discharge vertically (3¼" x
10" or 7" Round), horizontally (3V4"x 10" only) or non-ducted.
For vertical or horizontal discharge, run ductwork between
the hood location and a roof cap or wall cap.
For best results, use a minimum number of transitions and
elbows.
ROOF CAP
SOFFIT
CABINET ---_.1
oo
24" - 30" ABOVE
COOKING SURFACE
3W'X 10" or
7" ROUND DUCT
" (For vertical discharge)
HOUSE WIRING
or Back of hood)
CAP
3W' X 10" DUCT
(For horizontal discharge)
2. Use these diagrams for proper placement of ductwork and
electrical cutout in cabinet or wall.
For a non-ducted installation, DO NOT cut a duct access
hole.
3. Run house wiring between service panel and hood
location.
3W'X 10" 1
HOOD MOUNTING SCREWS (4)_VERT CAL DUCT NG
1315/16`' (30" hood) 1315/16" (30"hood)
(36" hood)_ _ 1615/16'' (36"hood)
_ CABINET FRONT
71/2"......_
CABmNET BOTTOM
T VERTICAL DUCT
ACCESS HOLE
t ELECTRICAL
ACCESS HOLE
WOOD SHIMS CENTER
(recessed-bottom LINE (in cabinet bottom)
cabinets only)
- i
7" ROUND
HOOD MOUNTING SCREWS (4) [VERTICAL DUCTING
WOOD SHIMS t ELECTRmCAL
ACCESS HOLE
(recessed-bottom CENTER (in cabinet bottom)
cabinets onmy) LiNE
WOODSHIMS l 31A'X10" ]
(recessed-bottom HORIZONTAL DUOTING
cabinets only)
CABmNET FRONT
CABINET-
\ [BOTTOM
\
--_ 1315/16" (so" hood) _ "_""_ 1 315/16 '' (30" hood)
/
(36" hood) (36" hood)
1615/16`'
1615/16''
" HOOD
ELECTRICAL
MOUNTING CENTER
ACCESS HOLE
SCREWS (4) LINE (in wall)
To Next Page
Loading...
