1. Remove _ from nose of hood.
SHiPPiNG
TAPE
2. Remove , Aluminum Mesh Filter and
3%" × 10" Duct Connector from inside the hood. Set
filter and duct connector aside.
SHIPPING
TAPE
3¼"X10"
DUCT
CONNECTOR
ALUMINUM
MESH
FILTER
3. Remove WiringCover from inside the hood. Set cover
and mounting screw aside.
WIRING
COVER
{b
re
3"
4. Remove either top or back Wiring Knockout and install
approved Electricam Cabme Cmamp,
ELECTRICAL
CABLE CLAMP
WIRING
KNOCKOUT
To Next Page
Loading...
