5, Remove either top or back wiring knockout and install
approved Electrical Cable Clamp+,
If hood is to be installed Non-Ducted:
• Purchase a set of Clean Cooking Filters and attach
them to the aluminum mesh filters.
• Skip to Step 10 on page 9+
See page 4 for Clean Cooking Filter information,
Clean Cooking Filters available by calling Sears
at 1-800-4-MY-HOME ®
6. Remove appropriate Duct Knockout(s) from top or back of
hood.
ELECTRICAL
CABLE CLAMP
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for3_'x t0"
Vertical & for 7" Round
Discharge) _" _ .
i :
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3_/_"x 10"
Horizontal Discharge)
7. Horizontal Discharge Only: Remove the Plate infront of the
horizontal discharge knockout. Cut the Ties, fift plate out,
and discard plate. DO NOT REMOVE the Met IS_ held
in place with two Screws.
SCREW
TIES
To Next Page
Loading...
