Set Up the Machine
Plug in the Machine and Switch on the Power
NOTE:
Plug
connector /
Machine
plug
J
Before inserting the plug into your
machine, be sure the power sw_tch _s
OFF
1. Check your outlet to be sure it is a110to120
Volt AC outlet.
2. Insert the machine plug Into the three-prong
plug connector, as shown. It will only fit one
way.
3. Insert the power supply plug into the outlet.
SECTION 2.
light
4.
Power __
Push the light and power switch to turn
on the power and sewing light.
SAFETY FEATURE:
Your machme will not operate unless the
tight/power switch _s turned on, If you are
interrupted or stop sewing, turn off the
light/power switch to prevent injury to
children.
PREPARE THE MACHINE FOR SEWING
= Foot Control Use
¢-
/
Foot control
J
The foot control regulates the speed at
which you sew.
To increase speed, gently press down with
the ball of your foot.
To decrease speed, release your foot pres-
sure slightly.
NOTE: The foot control is sensitive and
will increase or decrease your
sewing speed immediately+
Practice on a scrap of fabric to
regulate your sewing speed to
your taste and needs,
To Next Page
Loading...
