ELECTRICAL REQUIREMENTS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the electrical current.
This appliance is equipped with a cord having a
grounding wire with a grounding plug. The plug must
be plugged into an outlet that is properly installed
and grounded.
IMPORTANT WARNING
An empty refrigerator can pose a threat to children.
To render the unit harmless we strongly recommend
removing the door prior to disposal.
WARNING - Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions
are not completely understood, or if doubt exists as to
whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your
refrigerator to extension cords or together with any
other appliance in the same wall outlet.
SAVE THESE INSTRUCTIONS!
Remove exterior and interior packings, wipe the
outside thoroughly with a soft dry cloth and the inside
with a wet, lukewarm cloth. Avoid placing the unit in
a narrow recess or near any heat source, direct
sunlight, or moisture. Let air circulate freely around
the unit. Keep the rear of the refrigerator 5 inches
away from the wall.
LOCATION
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between the back of the
refrigerator and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight
may affect the acrylic coating. Heat sources
nearby will cause higher electricity consumption.
To avoid vibration, the unit must be set level. This is
accomplished by adjusting the front leveling leg,
located under the refrigerator.
NOTES:
• This appliance is intended for FREE-STANDING
INSTALLATION ONLY, and is NOT intended to be
built-in.
• Before connecting this appliance to electrical power
supply, leave it to stand for approx. 24 hours, which
will reduce the possibility of malfunction in the
cooling system due to transport handling.
• This appliance is approved for INDOOR USE ONLY
and is NOT intended for outdoor operation.
IMPORTANT: Install this appliance in a room where
the ambient temperature is between 55°F (13°C) and
77°F (25°C). If the temperature around the
appliance is too low or high, cooling ability may be
adversely affected.
Important Note: This appliance uses semi-conductor
technology to cool the interior cabinet, and is
designed to operate at a maximum of 30°F (16°C)
degrees below the room's ambient temperature.
3
To Next Page
Loading...
