iNSTALLATiON REQUIREMENTS
....._!_i;OOiiiiS _i!!_!i!ii_ili_i:i;:iiiii::::_;ii!!_!i!i!i!;ili::S
Gather the required tools and parts before starting installation.
The parts supplied are in the washer drum.
Tools needed for connec_ng the water inlet hoses
[] Pliers
[] Flashlight (optional)
Pedestal
You have the option of purchasing a pedestal for this washer.
You may select a 14"(35.5cm) pedestal. Remember that the
pedestal will add to the total height of the unit.
Tools needed for installaSon
[] Open end wrenches 17 mm and 13 mm
[] Level
[] Wood block
[] Ruler or measuring tape
Parts supplied
_ (use for the upper bolt hole)
Wrench Bolt hole covers
Water supply hose
Hose guide Plastic Zip Hose Tie
Alternate Parts
Parts listed are available from your local Sears store or Sears
Service Center. For further information, please call 1-800-4-MY-
HOME@ {1-800-469-4663).
Optional pedesta[
To order, call your local Sears store. For further information,
please call 1-800-4-MY-HOME@ (1-800-469-4993).
Pedestal Height Color Model Number
14" (35.5cm) Glacier White 19101
14"(35.5cm) Imperial Silver 19107
Stacking Kit
Are you on planing to stack your Kenmore washer and dryer?
To do so, purchase an optional stacking kit (Model:18888)
from your local Sears store or Sears Service Center. Follow
instructions included with the kit. See "Location Requirements."
if You Have You Will Need to Buy
Laundry tub or Sump pump system (if not already
standpipe taller than available)
96" (2.4 m)
Overhead sewer
Standard 20 gal. (76 L), 30" (76.2 cm)
tall drain tub or utility sink and sump
pump (available from local plumbing
suppliers)
Drain hose too short 3.3 ft (1.0 m) drain hose extension kit,
Part Number DC82-01012A
_i_i_¸ _Ji_,¸¸
5
To Next Page
Loading...
Need help?
General
