Kenmore 79032353000 User Manual

iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALIFIED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
if the information in this manual is not followed exactly, a fire
or explosion may result causing property damage, personal injury or death.
FOR YOUR SAFETY:
Do not store or use gasoline or other Nammable vapors and
liquids in the vicinity of this or any other appliance.
WHAT TO DO iF YOU SMELL GAS:
* Do not try to light any appliance.
* Do nottouch any electricalswitch; do not use any phone in your building.
* immediately call your gas supplier from a neighbor's phone.
Follow the gas supplier's instructions.
* if you cannot reach your gas supplier, call the fire department.
installation and service must be performed by a qualified
installer, service agency or the gas supplier.
Appliances Installed in the
state of Massachusetts:
This Appliance can only
be installed in the state
of Massachusetts by a
Massachusetts licensed
plumber or gas fitter.
This appliance must be
installed with a three (3)
foot / 36 in. long flexible
gas connector. A "T"
handle type manual gas
valve must be installed in
the gas supply line to this
appliance.
30" Min. *
(76.2 cm)
Gas Cooktop
Cutout Dimensions
Figure I
30" Gas Cookto 27 1,A 28 1/2 19 3A
All dimensions are stated in inches and (cm).
Dimension H includes a 5" (12.7 cm) space underneath the cooktop for connection to gas supply line.
NOTE: Wiring diagrams for this cooktop are enclosed in this booklet
Printed in United States
318205452 (1006) Rev. B
English - pages 1-9
Espa_ol - p6ginas 10-18
Wiring Diagram 19-20

Kenmore 79032353000 Specifications

General

Brand	Kenmore
Model Number	79032353000
Product Type	Cooktop
Fuel Type	Electric
Number of Burners	5
Burner Type	Radiant
Burner Size	Various
Surface Material	Ceramic Glass
Control Type	Knob
Power Source	Electric
Voltage	240 V
Installation Type	Drop-In
Color	Black
Material	Ceramic Glass
Weight	50 lbs
Width	36 inches

Summary

IMPORTANT SAFETY INSTRUCTIONS

Under Counter Oven Installation

Gas Cooktop Over Oven Installation

Wall Outlet Location

Cooktop Installation Procedures

Clamp Down Information

Securing the cooktop to the countertop using brackets and screws.

Countertop Cutout and Seal

Fitting the cooktop into the cutout and using sealant.

Gas Supply and Conversion

Adequate Gas Supply Provision

Ensuring correct natural gas pressure and supply line size.

LP/Propane Gas Conversion

Instructions for converting the appliance to LP/Propane gas.

Pressure Regulator and Gas Connections

Pressure Regulator Installation

Properly installing the regulator with arrow pointing up.

Checking Gas Connections for Leaks

Using leak detector to check all gas joints for safety.

Valve Alignment Check

Verifying control knob valve alignment after gas connection.

Electrical Requirements and Grounding

Operation Check

Burner Flame Adjustment

Regular Burner Low Flame Adjustment

Adjusting the minimum flame size for regular surface burners.

Dual Burner Low Flame Adjustment

Adjusting low flame for dual burner components.

Final Installation Steps and Information

Hookup Completion and Airflow

Verifying connections and ensuring unobstructed air supply.

Model and Serial Number Location

Finding the serial plate for service and parts.

Pre-Service Checklist

Reviewing common issues before contacting customer support.