Follow the fabric care label instructions
on items to be washed.
For best results
A signal will sound at the end of the cycle if the • Cycle
Signal option has been selected.
Remove items from the washer when the cycle ends •
and place in dryer, line dry or dry fl at as directed on the
fabric care label.
Excess wrinkling, color transfer or odors may develop •
in items left in the washer after the cycle has ended, if
not removed promptly.
To select or delete an option, press • OPTIONS; then,
while the indicator is blinking, press Select. The indica-
tor will light when the option has been selected. It will
no longer be lighted when the option has been deleted.
Adjustments to a cycle will be remembered and re-•
called each time that cycle is selected in the future.
To return to factory settings, press the• Pause/Cancel
and Select buttons at the same time and hold until the
signal sounds.
If changes to the settings or options are attempted •
after the cycle starts, you will hear several beeps when
the buttons are pressed. To change the settings or op-
tions, press Pause/Cancel twice, make the new selec-
tions and press Start again.
To change the cycle once the cycle has begun, press •
Pause/Cancel twice, select a new cycle, and press
Start again. Just turning the cycle selector knob will
not change the cycle.
To stop the cycle, press • Pause/Cancel twice.
7 Start the washer.
Close the door and press •
START
. The washer will not
operate with the door open.
If desired, select •
Delay Start
to delay the beginning of
the cycle for 8 or up to 12 or 14 hours depending on
your model.
As a safety measure, the door will automatically lock •
during the entire wash cycle and the
Door Lock
indica-
tor will be lighted.
A forgotten item can be added to the wash drum if the •
Add Garment
indicator is lighted. Press
Pause/Cancel
once. Open the door, add the item, close the door and
press
START
to resume the cycle.
Washing Procedures, continued
6
To provide the best care for your laundry, not every
setting or option is available with every cycle. If a setting or
option is not available for the cycle selected, the indicator will
not light.
If the cycle is interrupted during spin, it will take ap-
proximately 2-3 minutes for the door lock to release. DO NOT
force open the door.
- ENTRAPMENT and TIP-OVER HAZARD -
Do not leave the door open if there are small children or pets
present. An open door could entice children to hang on the
door or crawl inside the washer. If there are no small children
present, you may leave the door ajar to prevent odor build up.
Press and hold both for ten seconds
to return to factory settings.
To Next Page
Loading...
Need help?
General