Kenmore DS4095 User Manual

- 12 -
Flex
Wand
Button
CLEANING WITH THE HAND VACUUM
To start the vacuum, press the on/off trigger
button. Once turned on, the battery level
indicator will be lit.
The vacuum starts in the ECO speed
position. To switch the speed to HIGH, press
the speed change button. Press the speed
change button again to switch back to ECO
speed.
To turn the vacuum off, press the on/off
trigger button again.
When vacuuming on plush carpet, use ECO
mode for best performance.
NOTE:
When battery power decreases
to about 10% remaining, the battery level
indicator will start red flashing. The flashing
will continue until the unit is charged or is
completely out of battery power.
USING THE EASYREACH
™
WAND
In order to easily access hard-to-reach
areas under furniture without having to
bend down, press the flex wand button to
position the wand into a lower angle.
To take the vacuum back to the straight
position, lift up the handheld vacuum. Once
straightened, the wand will lock in place.
VACUUM OPERATION
2. Install the combination tool onto the end
of the hand vacuum.
3. When finished cleaning, turn the hand
vacuum OFF and remove the combination
tool.
Wand Release Button
Easily clean messes on furniture, upholstery,
stairs and other hard-to-reach areas with
the included combination tool.
1. To detach the hand vacuum, press the
wand release button and pull the wand
from the hand vacuum.

Kenmore DS4095 Specifications

General

Brand	Kenmore
Model	DS4095
Category	Vacuum Cleaner
Language	English