3. Lower the wand from upright position by
pressing on the HANDLE RELEASE pedal.
4. Select a pile height setting by pressing
the
ADJUSTMENT
pedal on the rear of
the PowerMate
®
. The pile height setting
shows on the indicator.
SUGGESTED PILE HEIGHT
SETTINGS
Attention: Refer to your carpet
manufacturers cleaning recommendations.
Some more delicate carpets may require
that they be vacuumed with the PowerMate
®
event carpet
damage.
For best deep down cleaning, use the XLO
setting. However, you may need to raise the
height to make some jobs easier, such as
scatter rugs and some deep pile carpets,
and to prevent the vacuum cleaner from
shutting o. Suggested settings are:
HI – Shag, deep pile, super-soft, or
ultraplush carpets, and scatter rugs.
MED – Medium to deep pile.
LO – Low to medium pile.
XLO –
NOTE:
HARDFLOOR
The preferred setting for many
carpets and also f
CAUTION
DO NOT leave the PowerMate
®
running
in one spot for any length of time.
Damage to carpet may occur.
- 11 -
CAUTION
Product Damage Hazard
Use care if the PowerMate
®
and wand is
left in the upright position as it may tip
over easily. Property damage can occur if
tipped.
5. Select a position on the handle 3-way
Slide the switch forward to
the CARPET position to turn on
suction from the canister motor
and the
PowerMate
®
agitator.
The CARPET indicator button will
turn green, and the
PowerMate
®
agitator will start to spin.
Slide the switch forward to the
HARDFLOOR position to turn on
canister motor suction only. The
HARDFLOOR indicator button will
turn green, and the
PowerMate
®
agitator will not spin.
Slide the switch all the way back to turn the
CARPET and
HARDFLOOR indicators will both become gray.
HARDFLOOR
HARDFLOOR
CARPET /
To Next Page
Loading...
Need help?
General
