INSTALLATION REQUIREMENTS
Work Surface Dimensions
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
• Measuring tape
• Level
The work surface can be installed on top of a front-loading
washer and dryer pair situated next to each other. The washer
and dryer must be level side to side and front to back and at the
same height. Proper installation is your responsibility.
Installation Spacing
• The work surface will fit on top of a washer and dryer that are
each 27" (68.6 cm) wide and have a spacing of approximately
1" (2.5 cm) between them for the alignment pads.
1 "
(2_5 cm)
25"
(63.5 cm)
Top view
NOTE: The work surface will add 3" (7.6 cm) to the overall height
of your washer and dryer.
Front edge
27 3/8" 1 27 3/s"
(69.5 cm) _ "_--- (69.5 cm)
ill f
Back edge
A
Bottom view
A. Alignment pads
B. Side pads
To Next Page
Loading...
