SECTION !1. GETTING READYTO SEW
Connecting Machine to Power Supply
(_DPower supply plug
Outlet
(_ Machine plug
(_) Power switch
0 Machine socket
_') Light bulb
Before connecting the power cord, make sure the
voltage and frequency shown on the machine con-
form to your electrical power..
1. Turn off the power switch (_Do
2o Insert the machine plug _ into the machine
socket (_.
3o insert the power supply plug (!) into the outlet (_).
4, Turn the power switch (_) to turn on the power
and sewing light (_.
For Your Safety
•* While in operation, always keep your eye on the
sewing area° Do not touch any moving parts
such as the thread take-up lever, handwheel or
needle°
• Always turn off the power switch and unplug from
the power supply:
- When leaving the machine unattended,,
- When attaching or removing any parts.
- When cleaning the machine.
'_ Do not place anything on the foot control, when
not sewing.
Operating instructions:
"For appliances with a polarized plug (one blade
wider than the other)°
To reduce the risk of electric shock, this plug is
intended to fit in a polarized outlet only one way. tf it
does not fit fully in the outlet, reverse the plug. If it
still does not fit, contact a qualified electrician to
install the power outlet.. Do not modify the plug in
any way."
"Foot Controller Model YC-482P for use with Sew-
ing Machine Model 385J2216XXX."
XXX - represents numbers 000 through 999.
Controlling Sewing Speed
Sewing speed can be varied by the foot control,.
The harder you press on the foot control, the faster
the machine runs.
t J"
f
.J
J
6
To Next Page
Loading...
Need help?
General
