19
ENGLISH
Follow the instructions in the kit. These
kits are available at your local Sears
store or Sears Service Center.
ROUTE THE VENT
Typical installations for left or right side
exhausting
Rear exhaust installations for offset
connections with close clearances –
(see p. 22)
Rear exhaust installations for standard
offset connections – (see pgs. 20-21).
Avoid pushing the dryer tightly against
a wall. This can crush or kink the vent.
Use the straightest path you can, where
possible. Avoid 90° turns.
Typical installations exhaust from the rear
of the dryer.
wWARNING
Fire Hazard
Cover unused exhaust holes with
one of the following kits:
279818 (white)
279819 (almond)
279915 (graphite)
279925 (bisque)
Contact your local dealer.
Failure to follow these instructions
can result in death, fire,
electrical shock or serious injury.
This dryer may be converted to exhaust
out the right or left side or through the
bottom. To convert the dryer, one of the
following kits must be used.
Exhaust Kit No. 279818 (white)
Exhaust Kit No. 279819 (almond)
Exhaust Kit No. 279915 (graphite)
Exhaust Kit No. 279925 (bisque)
Typical installations for bottom exhausting
To Next Page
Loading...
Need help?
General